Satel SATELLINE-EASy Podręcznik Użytkownika Strona 30

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 104
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 29
SATELLINE-EASy Pro
User Guide v.1.5
30
FEC = ON (FEC OFF state supported in PCC Transparent FST protocol implementation)
Scrambling = ON
Data Security Code set to = 0 (=not used)
Local Address= 0…254 (0 by default)
Pacific Crest modem receives messages from SATELLINE modems that have their TX1
address matching the Local Address.
Remote address=0…255 (255 by default, that is the broadcast address to be received by
all). SATELLINE modems receive the message from a Pacific Crest modem, provided their
RX1 address matches the Remote Address of a Pacific Crest transmitter (or if the message
has the broadcast address 255).
SATELLINE modems must have the following key settings:
FEC OFF (because the FEC here means SATEL 3AS FEC, not Pacific Crest/TRIMTALK FEC)
Error check OFF
Full CRC16 check OFF
Radio Compatibility (according to selected Pacific Crest protocol mode setting)
Pacific Crest 4-FSK
Pacific Crest GMSK
TRIMTALK GMSK, RX fitted to Pacific Crest transmitters
TRIMTALK GMSK, RX fitted to Trimble transmitters
PCC-FST
Addressing:
When TX address is selected ON, then TX1 address is used like PDL Remote address
that is the destination address for the transmitted messages.
Default value is 0x00FF (=255) (note the hexadecimal format of the setting)
When RX Address is selected ON, then RX1 address is used like PDL Local address
Default value is 0x0000 (=0) (note the hexadecimal format of the setting)
Note: Addresses are NOT applicable in TRIMTALK 450s mode so SATELLINE modems
must have their RX/TX addresses OFF with Option3.
The configuration tools and settings are different between SATELLINE and Pacific Crest modems:
Pacific Crest modems are configured via the serial port using PDLCONF Windows
TM
program that sends binary control messages to the serial port of the modem.
SATELLINE-EASy Pro radio modems are configured via the serial port using any ordinary
terminal program or SATEL Configuration Manager PC-program.
The table below shows the analogy of settings between Pacific Crest and SATELLINE radio
modems (status in firmware version v3. 46.3).
Pacific Crest setting
Corresponding SATELLINE-EASy Pro setting
Identification: Owner
(not implemented)
Identification: Channel Bandwidth
Channel spacing
Identification: RF Power
TX power
Radio Link: Channel Selection Type
(Manual)
Radio frequency
Radio Link: Current Channel
Radio frequency
Radio Link: Link Rate
The fixed link rates are:
Przeglądanie stron 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag